Orbit 14 installer manual

Many locations have been factory- programmed with default parameters. Installation Manual Page Programming Locations Disable the option of resetting the system to the factory defaults by using the default jumper. It provides greater proprietary security when viewing Central Station parameters. For example, for account number , enter Page 31 Locations: Zone 1 Digit : Zone Type Day Zone Usually assigned to an infrequently used door, such as an emergency door or a movable skylight. These outputs help operate external devices in response to a number of system activities related to alarms, zones, any general system event or the actions of a particular user.

The UO is activated for several seconds pulse , after which is deactivated. If this is not done, it will be impossible to arm the panel. Locations and allow you define the communication format as defined by the Central Station CS. If the telephone line is cut for more than four minutes, supervision causes phone line trouble.

Be sure to check with Central Station personnel if restorals are permitted and, if so, what codes are required. Page 57 Notes Page 58 Notes Because Seller does not install or You can contact us through our website www. Print page 1 Print document 60 pages. Rename the bookmark. Delete bookmark? Cancel Delete. Delete from my manuals? Sign In OR. Don't have an account? Sign up! Restore password.

Upload manual. Home About Contact. The LCD keypad is a visual interface tool that helps you operate the Orbit 14 panel. The operating procedures for the LCD are. For full information reg arding the operation of the Orbit - 14 refer to the Orbit -. The Power LED indicates system operation.

The system is operating properly from premises AC power; its backup battery is in good. The system is inoperative due to lack of power from both premises AC and backup battery ;. Indicates a trouble condition when the s ystem is disarmed. If a trouble condition exists, the Power LED will flash only when the system is in its disarmed state.

Once the. The Arm LED indicates whether or not the system's intrusion detectors are armed. The system's intrusion detectors are armed.